Copier List - Canon ImageRunner iR8500 Series Service Manual
Hide thumbs
Also See for ImageRunner iR8500 Series:
- Service manual (813 pages) ,
- Servise manual (655 pages) ,
- Function manual (167 pages)
Table of Contents
Advertisement
Sub-item
TR-TMDM
17.6.1.3 Copier List
iR85+
<BODY>
Sub-item
PO-CNT
TRNSG-SW
MODEL-SZ
FIX-TEMP
FUZZY
CNT-W/PR
CONFIG
TR-SP-C1
COPIER >OPTION >LCNS-TR
Use it to obtain a transfer license key in conjunction with transfer invalidation (for
tandem configuration).
COPIER > OPTION > BODY
Use it to turn on/off potential control.
<Setting value>
0: off, 1: on (default)
Use it to select toner guide bias control mode.
<Setting value>
0: 200 V for absolute water content of 22 g or more; 600 V for others
1: fixed to 600 V
2: fixed to 200 V
3: 200 V for absolute water content of 18 g or more; 600 V for others (default)
4: 200 V for absolute water content of 14 g or more; 600 V for others
Switching regular resized display and ADF document size detection
<Setting value>
0: AB (6R5E) [Default]
1: INCH (5R4E)
2: A (3R3E)
3: AB/INCH (6R5E)
Setting the down sequence start temperature for thick paper mode
<Setting value>
0: 194 deg C
1: 189 deg C (default)
2: 184 deg C
Use it to turn on/off fuzzy control and to make environment settings.
MEMO:
- The selection will affect pre-transfer, transfer, and separation charging
currents.
- Selecting 1 through 3 will make the operation independent of the envi-
ronment sensor.
<Setting value>
0: fuzzy control ON (default),
1: low humidity environment mode (current level lower than standard),
2: normal humidity environment mode,
3: high humidity environment mode (current level higher than standard)
Use it to turn ON/OFF the mechanism to change density during printing (PDL
input).
<Setting value>
0: correct target value to enable change of density during printing (default)
1: do not change density during printing
Selecting several types of firmware installed on the hard disk and switching
the country, language, and paper size type of this machine
<Adjustment method>
XXYYZZAAXX: Country (UP), YY: Language (ja), ZZ (00) Destination
(00:CANON 01:OEM), AA (00): Paper size type (00:AB 01:Inch 02:A 03:All
size)
<Operating procedure>
1) Select <CONFIG>.
2) Select an item to reverse its display. Then press the + or - key to change the
contents.
3) Each time the + or - key is pressed, the contents change sequentially.
4) Display the intended contents at all items and press the OK key.
5) Turn the main power switch OFF and ON.
Use it to set the transfer/separation output setting when the right deck is
selected, thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
Description
T-17-187
Description
Chapter 17
Level
2
0008-7973
Level
1
1
1
1
1
1
1
1
17-167
Advertisement
Chapters
Table of Contents
Troubleshooting
