Canon ImageRunner iR8500 Series Service Manual page 981

Sub-item
LGSW-DSP Setting whether or not to display [Log display ON/OFF] on the User mode screen
[Default]
0: Do not display [Log display ON/OFF] [Default]
1: Display [Log display ON/OFF]
PCL-COPY Supporting the PCL command [COPIES Meru/Pinatubo/Hood]
<Setting value>
0: Control each page according to the command of the COPIES command
specified to the page [Default]
1: Meru/Pinatubo/Hood compatible mode
2 to 65535: Reserved
OUT-FD Use it to select face-down (FD) delivery at all times.
<Setting value>
0: use facedown output normally
1: use facedown output at all times
PRJOB-CP Setting the CCV count pulse at reception and report output
<Setting value>
0: Do not output count pulse [Default]
1: Output count pulse
DPT-ID-7 Registering the department ID and entering 7 digits for authentication
<Setting value>
0: Conventional [Default]
1: 7-digit input
RUI-RJT Disconnecting the HTTP port from RUI by three authentication failures
<Setting value>
0: Invalid [Default]
1: Valid
CTM-S06 Setting whether or not to erase the password from the export file of the file send
address
<Setting value>
0: Do not erase the password from the export file. [Default]
1: Erase the password from the export file.
FREG-SW Setting whether or not to display the free section of the MEAP counter (SEND)
<Setting value>
0: Do not display [Default]
1: Display
IFAX-SZL Enabling or disabling the send size limit in IFAX transmission (not via server
only)
<Setting value>
0: Send size limit enabled (via server/not via server)
1: Send size limit disabled (not via server only) [Default]
IFAX-PGD Setting whether or not to permit split send in pages (only beyond the upper limit
of the send data size)
<Setting value>
0: Do not permit split send in IFAX Simple mode transmission [Default]
1: Permit split send in IFAX Simple mode transmission
MEAPSAFE Turning the MEAP Safe mode ON or OFF
<Setting value>
0: OFF [Default]
1: ON (Safe mode)
TRAY-FLL Use it to enable or disable notification in response to the tray becoming full.
0: indicate that the output tray has become full when all available trays have
become full
1: indicate that the output tray has become full only when the special tray (if
selected) has become full or all trays have been identified as being full
PRNT-POS Use it to specify whether to stop or not to stop all subsequent jobs when a job is
canceled in the event of an error.
<Setting value>
0: do not stop all
1: stop all
AFN-PSWD Limiting access in User mode
<Setting value>
0: OFF (Transition to the User mode screen with no password request) [Default]
1: ON (Transition to the User mode screen after password matching)
PTJAM-RC Turning PDL jam recovery ON or OFF
<Setting value>
0: OFF (Do not recover)
1: ON (Recover) [Default]
COPIER > OPTION >USER
Description
Chapter 17
Level
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
17-137