Canon ImageRunner iR8500 Series Service Manual page 961

Sub-item
MMI
MN-CON
CARD
ALARM
SND-STUP
CA-KEY
<MISC-P>
Sub-item
P-PRINT
USER-PRT
LBL-PRNT
PRE-EXP
KEY-HIST
COPIER > FUNCTION > CLEAR
Description
Clearing the following settings in User mode
- Backup data (user-defined values) of common settings
- Various backup data (user-defined values), excluding fax
The settings are cleared when the main power switch is turned OFF and ON.
<Operating procedure>
1) Select this item and press the OK key.
2) Turn the main power switch OFF and ON.
Clearing RAM on the main controller circuit board
The RAM is cleared when the main power switch is turned OFF and ON.
<Operating procedure>
1) Select COPIER>FUNCTION>MISC-P>P-PRINT to print the contents of the
service mode.
2) Select this item and press the OK key.
3) Turn the main power switch OFF and ON.
4) Enter the P-PRINT output data as required.
Clearing the card ID (department) related data
The card ID related data is cleared when the main power switch is turned OFF and
ON.
<Operating procedure>
1) Select this item and press the OK key.
2) Turn the main power switch OFF and ON.
Clearing the alarm log
The alarm log is cleared when the main power switch is turned OFF and ON.
<Operating procedure>
1) Select this item and press the OK key.
2) Turn the main power switch OFF and ON.
Clearing the send-read settings
The send-read settings are cleared when the main power switch is turned OFF and
ON.
<Operating procedure>
1) Select this item and press the OK key.
2) Turn the main power switch OFF and ON.
Clearing the CA certificate and key pair
The CA certificate and key pair are cleared when the main power switch is turned
OFF and ON.
<Operating procedure>
1) Select this item and press the OK key.
2) Turn the main power switch OFF and ON.
T-17-151
COPIER > FUNCTION > MISC-P
Description
Printing out the service mode settings
<Operating procedure>
1) Select this item.
2) Press the OK key to start printing.
Printing out the user mode list
<Operating procedure>
1) Select this item.
2) Press the OK key to start printing.
Printing out the service label
<Operating procedure>
1) Load A4 or LTR paper on Cassette 1.
2) Select this item.
3) Press the OK key to start printing.
Checking the pre-exposure lamp (LED)
<Operating procedure>
1) Press this item to reverse its display.
2) Press the OK key. After executing each operation for several seconds, the
machine stops automatically. (All lit)
3) Press the OK key to start printing.
Reference
If the lighting of the pre-exposure lamp gives a problem to the photoconductor
drum, rotate the drum.
Printing out the operating section key input history
<Operating procedure>
1) Select this item.
2) Press the OK key to start printing.
Chapter 17
Level
1
1
1
1
2
2
Level
1
1
1
1
2
17-117