Canon ImageRunner iR8500 Series Service Manual page 1029

Sub-item
MODEL-SZ Switching regular resized display and ADF document size detection
<Setting value>
0: AB (6R5E) [Default]
1: INCH (5R4E)
2: A (3R3E)
3: AB/INCH (6R5E)
FIX-TEMP Setting the down sequence start temperature for thick paper mode
<Setting value>
0: 194 deg C
1: 189 deg C (default)
2: 184 deg C
FUZZY Use it to turn on/off fuzzy control and to make environment settings.
MEMO:
- The selection will affect pre-transfer, transfer, and separation charging
currents.
- Selecting 1 through 3 will make the operation independent of the envi-
ronment sensor.
<Setting value>
0: fuzzy control ON (default),
1: low humidity environment mode (current level lower than standard),
2: normal humidity environment mode,
3: high humidity environment mode (current level higher than standard)
CNT-W/PR Use it to turn ON/OFF the mechanism to change density during printing (PDL
input).
<Setting value>
0: correct target value to enable change of density during printing (default)
1: do not change density during printing
CONFIG Selecting several types of firmware installed on the hard disk and switching
the country, language, and paper size type of this machine
<Adjustment method>
XXYYZZAAXX: Country (UP), YY: Language (ja), ZZ (00) Destination
(00:CANON 01:OEM), AA (00): Paper size type (00:AB 01:Inch 02:A
03:All size)
<Operating procedure>
1) Select <CONFIG>.
2) Select an item to reverse its display. Then press the + or - key to change the
contents.
3) Each time the + or - key is pressed, the contents change sequentially.
4) Display the intended contents at all items and press the OK key.
5) Turn the main power switch OFF and ON.
TR-SP-C1 Use it to set the transfer/separation output setting when the right deck is
selected, thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C2 Use it to set the transfer/separation output setting when the left deck is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C3 Use it to set the transfer/separation output setting when the cassette 3 is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C4 Use it to set the transfer/separation output setting when the cassette 4 is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-MF Use it to set the transfer/separation output setting when the manual feed tray
is used, thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
COPIER > OPTION > BODY
Description
Chapter 17
Level
1
1
1
1
1
1
1
1
1
1
17-185