Canon ImageRunner iR8500 Series Service Manual page 1012

Chapter 17
Sub-item
TR-SP-C2
TR-SP-C3
TR-SP-C4
TR-SP-MF
TR-SP-DK
DEV-SLOW
STPL-SFT
BASE-SW
IDL-MODE
OHP-TEMP
OHP-CNT
FIX-TMP1
17-168
COPIER > OPTION > BODY
Description
Use it to set the transfer/separation output setting when the left deck is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
Use it to set the transfer/separation output setting when the cassette 3 is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
Use it to set the transfer/separation output setting when the cassette 4 is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
Use it to set the transfer/separation output setting when the manual feed tray
is used, thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
Use it to set the transfer/separation output setting when the side paper deck is
used.
<Setting value>
0: setting for plain power (default)
1: setting for recycled paper
2: setting for tracing paper
Use it to set the speed of the developing sleeve.
<Setting value>
0: in relation to environment
1: fixed to high speed
2: fixed to low speed (default)
Use it to specify where to execute shift stacking in staple mode.
<Setting value>
0: perform shift stacking in staple mode (as it is: default)
1: do not perform shift stacking in staple mode
Switching from the MEAP-Full mode to the Base model
<Setting value>
0: OFF (Base model), 1: ON (Full model)
Use it to select idle rotation mode for the developing assembly.
MEMO:
Set it to '2' or '3' if the image becomes distorted or too light.
<Setting value>
0: OFF (no idle rotation)
1: auto control based on readings of environment sensor (default)
2: start idle rotation when fixing roller temperature reaches 100 deg C
3: start idle rotation when main power switch goes ON
Use it to switch among temperature settings for transparency mode.
MEMO:
The fixing temperature will be lowered to improve separation of
transparencies from the fixing roller.
<Setting value>
0: 198 deg C (default)
1: 193 deg C
2: 188 deg C
3: 183 deg C
Use it to turn ON/OFF the potential control mechanism for transparency
mode.
<Setting value>
0: use target value obtained in potential control of transparency mode
(default)
1: do not use potential control in transparency mode
Use it to select a temperature for starting down-sequence for plain paper.
MEMO:
If the user wants priority on image quality, set it to '0'; on speed, set it to '2'.
<Setting value>
0: 183 deg C
1: 178 deg C (default)
2: 173 deg C
Level
1
1
1
1
1
1
1
1
2
2
2
2