Canon ImageRunner iR8500 Series Service Manual page 943

Sub-item
TOUCHCHK
<Input Key Numbers and Names>
<PART-CHK>
Sub-item
CL
CL-ON
MTR
MTR-ON
SL
COPIER > FUNCTION > PANEL
Adjusting the coordinate positions on the analog touchpanel
<Operating procedure>
- Align the press positions on the touchpanel and the coordinate positions on the
LCD section.
- If the LCD section has been replaced, execute this service mode.
1) Select TOUCHCHK to reverse its display. Then press the OK key.
2) Press sequentially the nine positive signs (+) that appear on the touchpanel in
order.
Key
0 to 9, #, and *
Reset
Stop
User Mode
Start
Clear
PIN
Help
Counter Check
COPIER > FUNCTION > PART-CHK
Specifying a clutch to check its operation
(Range: 1 to 21)
<Operating procedure>
1) Select this item.
2) Enter the code of the clutch from the ten-key pad.
3) Press the OK key.
4) Press CL-ON to check its operation.
Starting the clutch operation check
<Operating procedure>
1) Select this item and press the OK key to repeat ON and OFF in the following
pattern:
0.5-second ON ->10-second OFF -> 0.5-second ON -> 10-second OFF -> 0.5-
second ON -> OFF
Specifying a motor to check its operation
(Range: 1 to 13)
<Operating procedure>
1) Select this item.
2) Enter the code of the motor from the ten-key pad.
3) Press the OK key.
4) Press MTR-ON to check its operation.
Starting the motor operation check
<Operating procedure>
1) Select the item, and press the OK key.
- 20 sec ON -> OFF
- for hopper and duplex horizontal registration motor, 10 sec ON -> OFF
- for shift tray motor, stops at front/rear HP
- for vibration motor (M10/M20), ON/OFF operation repeats at intervals of
about 5 sec
Specifying a solenoid to check its operation
(Range: 1 to 14)
<Operating procedure>
1) Select this item.
2) Enter the code of the solenoid from the ten-key pad.
3) Press the OK key.
4) Press SOL-ON to check its operation.
Description
T-17-111
Screen Display
0 to 9, #, and *
RESET
STOP
USER
START
CLEAR
ID
?
BILL
T-17-112
Description
Chapter 17
Level
1
Level
1
1
1
1
1
17-99