Adjusting The Image Position Of Copier Output (Book Mode) - Canon ImageRunner iR8500 Series Service Manual

2) Loosen the two fixing screws [3] on the left/right of the cassette, and
make adjustments using the adjusting screw [4].
[3]
If you have adjusted cassette 3 or 4, be sure to execute the following
service mode:
If you have adjusted cassette 3,
COPIER>ADJUST>CST-ADJ>C3-STMTR
COPIER>ADJUST>CST-ADJ>C3-A4R
If you have adjusted cassette 4,
COPIER>ADJUST>CST-ADJ>C4-STMTR
COPIER>ADJUST>CST-ADJ>C4-A4R
14.2.6 Adjusting the Image Position of Copier
Output (book mode)
iR105i/iR105+ / iR9070
Make these adjustments only after you have adjusted the image position
of printer output.
1) Adjusting the Image Leading Edge Non-Image Width
Place the NA3 Test Chart on the copyboard glass, and make a copy
to check the image leading edge non-image width:
Standard: 4 +1.5 mm, -1.0 mm
Adjustment: COPIER> ADJUST> ADJ-XY> ADJ-X
- A higher value increases the margin.
- A lower value decreases the margin.
[2]
[1]
F-14-32
[3]
[4]
F-14-33
0007-0558
2) Adjusting the Image Front Non-Image Width
Place the NA3 Test Chart on the copyboard glass, and make a copy
to check the image front non-image width.
Standard: 2.5 -/+1.5 mm
Adjustment: COPIER> ADJUST> ADJ-XY> ADJ-Y
- A higher value increases the margin.
- A lower value decreases the margin.
2.5 1.5mm
3) Adjusting the Image Front Non-Image Width of Double-Sided Copy
Images
Place the NA3 Test Chart on the copyboard glass, and make a
double-sided copy to check the front non-image width of the 2nd
side.
Standard: 2.5 -/+2.0 mm
Adjustment: COPIER> ADJUST> FEED-ADJ> ADJ-REFER
- A higher value increases the margin.
- A lower value decreases the margin.
2.5 2.0mm
4) Adjusting the Image Front Margin for the Manual Feed Tray and the
Side Paper Deck (accessory)
Place the NA3 Test Chart on the copyboard glass, and make a
double-sided copy to check the front non-image width of the 2nd side
image.
Standard: 2.5 -/+1.5 mm
Chapter 14
4+1.5mm,-1.0mm
F-14-34
F-14-35
F-14-36
14-21