Canon ImageRunner iR8500 Series Service Manual page 118

Chapter 2
6) Holding the grips on the delivery side (front, rear) of the machine, lift
the machine slightly to remove the remaining pad [1] and the plastic
bag at the same time.
7) Shift up the 2 adjusters [1] (front) found on the bottom for the
machine, and check that they are unlocked.
8) Take out the 2 slope plates [2] from the middle of the skid [1].
2-16
F-2-36
F-2-37
[1]
[1]
F-2-38
[1]
9) Remove the 2 pins [2] taped in place to the slope plate [1].
Turn over the slope plate [1], and fit the pin [2] (1 pc. each) while
matching the pin holes in the skid and the pin hole in the slope plate.
Holding the grips (front, rear) on the delivery side of the machine, slide
the machine along the slope plates, then off the skid.
[1]
10) Take out the parts and attachments from the cardboard box that
comes with the machine; then, check to make sure that none of the
foregoing items is missing.
11) Open the left and right protrusions [1] of the grip you fitted in step
4) using a screwdriver [3]; then, detach the grip [1].
[2]
F-2-39
[2]
F-2-40