Sorter - Canon ImageRunner iR8500 Series Service Manual

Chapter 17
STRD-S
STRD-L
RVM-SPD

17.4.3 SORTER

17.4.3.1 Sorter List
iR105i/iR105+ / iR9070
SORTER > ADJUST
Sub-item
PNCH-HLE
17.4.3.2 Sorter List
/ iR8070
SORTER > ADJUST
Sub-item
17-92
Use it to adjust the scanner stop position for stream reading mode (smallsize).
<Setting range> -25 to 25 (unit: 0.1 mm)
Stream reading scanner stop
position
Higher value
Lower value
Use it to adjust the scanner stop position for stream reading mode (largesize).
<Setting range> -25 to 25 (unit: 0.1 mm)
<Using the Mode>
Same as in FEEDER> ADJUST> STRD-S.
Use it to adjust the speed of the reversal motor.
MEMO:
A higher value increases the speed.
<Setting range> -30 to 30 (unit: 0.1%)
SORTER > ADJUST
Use it to adjust the punch hole position (paper feed direction) when the puncher unit is
used.
<Setting range> -23 to 23 (unit: about 0.5 mm)
<Using the Mode>
1) Make a print of the Test Chart, and check the position of the holes.
2) Select the item, and change the setting to adjust.
3) Press the OK key.
4) Make a print of the Test Chart once again, and check to see if the position of the holes
is as indicated.
Paper
Feed
direction
Higher value
SORTER > ADJUST
Copyboard glass
T-17-99
Description
Lower value
T-17-100
Description
1
1
2
0008-4951
Level
1
0008-7962
Level