Mounting The Charging Assembly - Canon ImageRunner iR8500 Series Service Manual

[1]
Do not start mounting work before the solvent has become completely
dry.
9) Remove the screw [1], and detach the pretransfer charging assembly
cover [2].
[2]
10) Disconnect the connector [1], and release the locking lever [3] of the
pre-transfer charging assembly [2]; then, take out the pre-transfer
charging assembly.
Using alcohol, clean the pre-transfer charging wire.
11) With the lock released, slide in the primary charging assembly, and
connect the connector.
[2]
[3]
F-2-107
[1]
F-2-108
[1]
[3]
[2]
F-2-109
Check to make sure that the solvent is fully dry.
12) With the lock released, slide in the pretransfer charging assembly,
and connect the connector.
[2]
- Check to make sure that the solvent is fully dry.
- Check to make sure that the one-way arm [1] of the pretransfer
charging assembly is on the eccentric cam [2].
13) Mount the primary charging assembly cover and the pre-transfer
charging assembly cover with a screw (1 pc. each).
14) Close the front cover.

2.2.15 Mounting the Charging Assembly

/ iR8070
1) Remove the screw [2], and detach the transfer/separation assembly
front cover [1].
[2]
2) Remove the fixing [1] (1 screw [2]), and disconnect the connector [3].
[1]
3) While holding down the front and rear of the transfer/separation
charging assembly [1], pull it by 1 cm toward the front; then, detach
it toward the upper left.
Chapter 2
[1]
F-2-110
0007-2060
[1]
F-2-111
[2]
[3]
F-2-112
2-29