Canon ImageRunner iR8500 Series Service Manual page 831

YY Description
*3 01 The ongoing write operation has been
suspended (at startup).
*4 01 The ongoing write operation has been
suspended (at startup).
*5 02 A file system error has occurred.
*6 02 There is a file system error.
*7 02 A file system error has occurred.
*8 02 A file system error has occurred.
*9 03 There is poor contact of the HDD, or
a v.x Works system error has
occurred.
*10 11,21 The HDD has poor contact.
Remedy
To run a recovery session for the boot partition,
you will have to use safe mode in combination with
the SST.
1. Set '0' for TYPE-TYPE, and execute HDD-
CHECK (40 to 50 min). Thereafter, turn off and the
back on the power.
2. If the symptom still exits after the foregoing,
start download mode, and execute full formatting
using the SST, and re-install the system software
(System, Language, RUI). Thereafter, turn off and
then back on the power.
1. Set '0' for TYPE-TYPE, and execute HDD-
CHECK (40 to 50 min). Thereafter, turn off and
then back on the power.
2. If the symptom still exits after the foregoing,
execute HDD-CLEAR using TYPE-TYPE=1, 2, 3,
5. Thereafter, turn off and then back on the power.
1. Type in TYPE-TYPE of the partition in
question, and execute HDD-CLEAR. Thereafter,
turn off and then back on the main switch.
2. If the system still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.
The system software is designed so that the
information in this partition (e.g., address book,
filter) is not deleted inadvertently; i.e., you will not
the able to execute HDD-CLEAR from service
mode.
1. If possible, ask the user to back up the address
book data using the RUI.
2. From service mode, start download mode; then,
execute full formatting using the SST and re-install
the system software (System, Language, RUI).
Thereafter, turn off and the back on the main
power.
This type of error is highly rare.
1. Using TYPE-TYPE=1, 2, 3, 5, execute HDD-
CLEAR. Thereafter, turn off and then back on the
power.
2. If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.
The system software is designed so that a recovery
session will not run for the boot partition unless
you use safe mode in combination with the SST.
1. Start up in safe mode, and execute full
formatting using the SST and re-install the system
software (System, Language, RUI). Thereafter,
turn off and then on the main power.
2. If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.
1. Check the cable and power supply connectors.
2. If the symptom still exits after the foregoing,
start up in safe mode, and execute full formatting
using the SST and re-install the system software
(System, Language, RUI). Thereafter, turn off and
then back on the main power.
3. If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and re-install the system software.
This type of error is highly rare in relation to read/
write operations.
1. Check the cable and the power supply
connectors.
2.If the symptom still exits after the foregoing,
suspect a fault on the HDD, and replace the HDD
and install the system software.
Chapter 16
16-35