Installing The Adf; Cassette - Canon ImageRunner iR8500 Series Service Manual

Chapter 2
2) As needed, connect the reader unit anticondensation heater cable [1].

2.2.28 Installing the ADF

1) Remove the air cap from the connector/power supply cable of the
ADF.
2) Connect the ADF connector [1] to the socket found at the back of the
copier.
3) With the ADF open, mount the ADF original tray [1] using 2 RS
tightening screws [2] (M4X8; white).
2-40
[1]
F-2-168
[1]
F-2-169
0007-3508
[1]
F-2-170
[2]
When mounting, fit the hook [3] of the ADF tray into the notch in the
copier; then, slide it to the left, and secure it with screws.

2.2.29 Cassette

iR105i/iR105+ / iR9070
Perform this step if the user is not planning to use Inch papers.
1) Press the releasing buttons of the cassette 3 and 4, and slide out the
cassettes to the front; then, take out the packing material.
2) Set the side guide plate [1] of the cassette (3/4) against the hole (A4/
A3) identified by the marking M.
Fit the non-inch block [2] that comes with the machine into the
following hole, making sure that it will not be pushed up from inside
the cassette.
Hole with marking A [3]: STMT-R
Hole with marking H [4]: LTR-R
[1]

2.2.30 Cassette

/ iR85+
[1]
[3]
F-2-171
0007-6693
[2]
[3]
[4]
F-2-172
0007-3510