Location Of The Fixing Web Solenoid (Sl2); Position Of The Fixing Web Solenoid (Sl2); Position Of The Delivery Flapper Solenoid (Sl3) - Canon ImageRunner iR8500 Series Service Manual

Chapter 14
-SL101(Side paper deck)
Side paper deck
SL 101
Screws

14.8.19 Location of the Fixing Web Solenoid (SL2)

iR105i/iR105+ / iR9070
a. If the Fixing Web Is New
Use the position of the solenoid [1] using the screw [2] so that the travel
of the drive lever is 8.2 mm.
[1]
[2]
b. If the Fixing Web Is Not New
Before removing the solenoid, check the position [A] of the drive lever
when the solenoid [1] is ON. After replacing the solenoid, make
adjustments using the screw [2] so that the position of the drive lever is
the same (when the solenoid is ON).
[1]
[2]

14.8.20 Position of the Fixing Web Solenoid (SL2)

/ iR85+ / iR8070
a. If the Fixing Web Is New
Use the screw [2] to adjust the position of the solenoid [1] so that the
travel of the drive lever is 8.2 mm.
14-64
Solenoid
(SL 101)
F-14-145
0007-0632
8.2mm
F-14-146
A
F-14-147
0008-8388
[1]
[2]
b. If the Fixing Web Has Been in Use
Before removing the solenoid, take note of the position [A] of the drive
lever when the solenoid [1] is ON; after replacement, adjust the position
of the drive lever using the screw [2] so that it is the same as it was
before removal when the solenoid goes on.
[1]
[2]
14.8.21 Position of the Delivery Flapper Solenoid
(SL3)
iR105i/iR105+ / iR9070
Use the screw [2] to adjust the position of the solenoid [1] so that the
drive lever is fully pushed when the solenoid is ON (i.e., when the steel
core is drawn).
Fully pushed.
14.8.22 Position of the Delivery Flapper Solenoid
(SL3)
/ iR85+ / iR8070
Use the screw [2] to adjust the position of the solenoid so that, when the
solenoid [1] goes on (i.e., when steel core is drawn), the drive lever is
fully pushed.
8.2mm
F-14-148
A
F-14-149
0007-0637
[1]
[2]
F-14-150
0008-8389