Canon ImageRunner iR8500 Series Service Manual page 136

Chapter 2
[4]
Close the toner cartridge cover [4].
5) Put the original delivery tray [1] over the lower arm, and hook the 2
claws [2] found at the bottom for the original delivery tray in the
notches of the right upper cover; check that there is no gap, and then
secure it in place with 2 RS tightening screws [3] (M4x10).
[3]
6) Hook the claw [1] of the upper arm [2] on the hole in the lower arm,
and temporarily fix the upper arm in place with 4 binding screws [3]
(M4x14).
[2]
[3]
7) Fit the positioning binding screw [1] (M4x14) so that the upper arm
[2] is at the angle desired by the user; then, fully tighten the binding
2-34
[2]
[1]
[3]
F-2-136
[1]
[2]
F-2-137
[3]
[3]
[2]
[1]
F-2-138
screw that was temporarily tightened.
Lead the control panel harness [3] through the 2 wire saddles [4].
At this time, check to make sure that the wire saddle [5] at the rear
matches the marking [6] on the control panel harness.
[1]
8) Pinch the control panel harness with a harness clip [1], and fit it to the
upper arm.
Hook the claw [2] found on the left side of the fate upper arm cover
[3], and put it over the upper arm.
[2]
Keep the harness clip [1] so that the side with a protrusion (thicker side)
is at the bottom.
The harness clip [1] will separate into two during the work. Continue the
work, as it will not affect its function.
9) Remove the binding screw [1], and detach the rear support cover [2]
of the control panel unit [3].
[2]
[1]
[4]
[2]
[6]
[5]
[3]
F-2-139
[1]
[3]
F-2-140