Canon ImageRunner iR8500 Series Service Manual page 673

5) Adjusting the Image Front Margin for Each Source of Paper
Make the following selections to select '1' (right deck): COPIER>
TEST> PG-PICK.
Then, generate the following to check the image front margin:
COPIER> TEST> PG56.
Likewise, make the following selections to select '2', '3', '4', and '8':
COPIER> TEST> PG5. Then, generate COPIER> TEST> PG5 to
check the image front margin.
Standard: 2.5 -/+1.5 mm
PG-PICK 1: right deck
PG-PICK 2: left deck
PG-PICK 3: cassette 3
PG-PICK 4: cassette 4
Adjustment: Adjusting the Fixing Position of Each Source of Paper
- Front Deck (left, right)
1) Slide out the deck, and loosen the 4 screws [2] and the 2 fixing screws
[3] of the cassette front cover [1].
[3]
[2]
2) Move the cassette guide assembly (front) [4] to the front or the rear to
make adjustments.
+
2.5mm 1.5mm
F-14-20
+
2.5mm 1.5mm
F-14-21
[3]
[2]
[2]
[1]
F-14-22
[4]
- Cassette (3/4)
1) Slide out the cassette, and remove the 2 screws [2] for the cassette
front cover [1].
2) Loosen the 2 fixing screws [3] found on the left/right of the cassette,
and adjust the position using the fixing screw [4].
[3]
If you have adjusted the cassette 3 or cassette 4, be sure to execute the
following:
- If you have replaced the cassette 3,
COPIER> ADJUST> CST-ADJ> C3-STMTR
COPIER> ADJUST> CST-ADJ> C3-A4R
- If you have replaced the cassette 4,
COPIER> ADJUST> CST-ADJ> C4-STMTR
COPIER> ADJUST> CST-ADJ> C4-A4R
14.2.5 Adjusting the Image Position for Printer
Output
/ iR85+ / iR8070
Standards for Image Position
Chapter 14
F-14-23
[2]
[1]
F-14-24
[3]
[4]
F-14-25
0008-8365
14-19