Canon ImageRunner iR8500 Series Service Manual page 120

Chapter 2
3) Take out the grip [1] from the box that comes with the machine.
[1]
4) Open the right upper cover, and slide the small face cover [1] to the
rear to detach; then, detach the large face cover [2].
Fit the grip [3] detached in step 3 at the front.
Close the right upper cover.
5) Holding the grips on the pickup side (front, rear) for the copier, lift
the machine slightly to remove the pad [1].
At this time, move the plastic bag [2] toward the remaining pad.
2-18
[2]
[1]
F-2-45
F-2-46
[1]
[3]
[2]
F-2-47
[2]
6) Holding the grips on the delivery side (front, rear) of the copier, lift
the machine slightly to remove the remaining pad [1] and the plastic
bag at the same time.
7) Shift up the 2 adjusters [1] (front) found on the bottom for the copier,
and check that they are unlocked.
8) Take out the 2 slope plates [2] from the middle of the skid [1].
[1]
F-2-48
[1]
F-2-49
[1]
[1]
F-2-50