Positioning The No. 1/2 Mirror Base - Canon ImageRunner iR8500 Series Service Manual

cable metal fixing is inside.
3) Hook the cable on each pulley, and temporarily fix one end to the
cable fixing plate and the other end to the hook of the reader frame.
4) Temporarily fix the cable metal fixing to the No. 1 mirror base (Do
not fully secure it).
5) Mount the reader paper frame.
When mounting the reader upper frame, be sure to go through the
following steps:
1) Fit the ten claws [1] of the reader frame correctly into the cut-offs in
the reader upper frame.
2) Secure the positions [2] of the six left/ right claws using screws.
3) Fit the two screws [3] at the end.
[1]

5.4.17.7 Positioning the No. 1/2 Mirror Base

/ iR8070
1) Set the pins of the mirror position tool as indicated.
F-5-182
[2]
[1]
[1]
[3]
[1]
F-5-183
0008-8059
[C]
[B]
Initial FY9-3009 configuration
(for rear)
[C]
[B]
[A]
Initial FY9-3009 configuration
(for front)
2) Insert the pins of the mirror positioning tool (front [2]/rear [3]) into
each of the holes [1]: No. 1 mirror base, No. 2 mirror base, and rail.
The position of the No. 2 mirror base is adjusted by sliding the cable
fixing plate to the front and the rear.
[3]
3) Secure the end of the cable so far temporarily fixed to the hook of the
reader frame using a spring.
4) Fully tighten the screw on the cable fixing plate.
5) Fully tighten the cable metal fixing on the No. 1 mirror base.
6) Detach the mirror positioning tool.
7) Reverse steps 1) through 6) for mounting.
Chapter 5
[A]
[C]
[B]
[A]
Configuration used for
the machine
(for rear)
[A]
[C]
[B]
Configuration used for
the machine
(for front)
F-5-184
[2]
[1]
F-5-185
[1]
F-5-186
5-53