Canon ImageRunner iR8500 Series Service Manual page 123

8) Take out the 2 slope plates [2] from the middle of the skid [1].
9) Remove the 2 pins [2] taped in place to the slope plate [1].
Turn over the slope plate [1], and fit the pin [2] (1 pc. each) while
matching the pin holes in the skid and the pin hole in the slope plate.
Holding the grips (front, rear) on the delivery side of the copier, slide
the machine along the slope plates, then off the skid.
[1]
[1]
F-2-61
[1]
[2]
F-2-62
[2]
10) Take out the parts and attachments from the cardboard box that
comes with the machine; then, check to make sure that none of the
foregoing items is missing.
11) Open the left and right protrusions [1] of the grip you fitted in step
4) using a screwdriver [3]; then, detach the grip [1].
[3]
[1]
[2]
[3]
[1]
12) Open the front cover [1] and then the compartment cover [2]; then,
store the grips [3] used in compartment behind the front cover.
Close the compartment cover, and close the front cover.
Chapter 2
[1]
F-2-63
[1]
[2]
[2]
F-2-64
2-21