Show Lldp Remote-Device - NETGEAR GSM7228PS Cli Manual

Term Definition
Errors The number of invalid LLDP frames received on the port.
Ageouts Total number of times a complete remote data entry was deleted for the port because the
Time to Live interval expired.
TLV Discards The number of TLVs discarded.
TLV Unknowns Total number of LLDP TLVs received on the port where the type value is in the reserved
range, and not recognized.
TLV MED Total number of LLDP MED TLVs received on the local ports.
TVL802.1 Total number of 802.1 LLDP TLVs received on the local ports.
TVL802.3 Total number of 802.3 LLDP TLVs received on the local ports.

show lldp remote-device

Use this command to display summary information about remote devices that transmit current
LLDP data to the system. You can show information about LLDP remote data received on all ports
or on a specific port.
Format
show lldp remote-device {<unit/slot/port> | all}
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the remote device.
RemID An internal identifier to the switch to mark each remote device to the system.
Chassis ID The ID that is sent by a remote device as part of the LLDP message, it is usually a MAC
address of the device.
Port ID The port number that transmitted the LLDPDU.
System Name The system name of the remote device.
Example: The following shows example CLI display output for the command.
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-177