Cam-Acl (Configuration) - Dell C9000 Series Reference Manual

example, transmission control protocol (TCP) and user datagram protocol (UDP) rules with port range
options might require more than one CAM entry.
• After you install a secondary RPM, copy the running-configuration to the startup-configuration so that
the new RPM has the correct CAM profile.
• You MUST save your changes and reboot the system for CAM profiling or allocations to take effect.

cam-acl (Configuration)

Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6
ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address
validation for DHCP, Ethernet Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based
Routing (PBR).
C9000 Series
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number [vman-qos
| vman-dual-qos number] ecfmacl number [nlbclusteracl number]
ipv4pbr number }openflow number | fcoe number} [iscsioptacl
number] [vrfv4acl number]
Parameters
default
l2acl number
ipv4acl number
Use the default CAM profile settings and set the CAM as follows:
• L2Acl : 5
• IPV4Acl : 4
• IPV6Acl : 0
• IPV4Qos : 2
• L2Qos : 1
• L2PT : 0
• IpMacAcl : 0
• VmanQos : 0
• VmanDualQos : 0
• EcfmAcl : 0
• nlbclusteracl: 0
• FcoeAcl : 0
• iscsiOptAcl : 0
• ipv4pbr : 0
• Openflow : 0
• fedgovacl : 0
• vrfv4Acl : 0
Enter the keyword l2acl and then the number of l2acl blocks.
The range is from 1 to 8.
Enter the keyword ipv4acl and then the number of FP blocks
for IPv4. The range is from 0 to 8.
Content Addressable Memory (CAM) 644