Installing Or Upgrading The Ip Softphone - Nortel 1110 Installation And Operation Manual

Page 228 of 630

Installing or upgrading the IP Softphone 2050

553-3001-368 Standard 26.00
Nortel IP Softphone 2050
a. Connect the coiled lower cord to the headset cord with the Quick
Disconnect connector. Ensure the Quick Disconnect connector is
securely fastened.
b. Connect the headset cord to the RJ9 jack on the adapter.
5 Connect the USB cable to the headset adapter and to one of the USB
jacks on the back of your PC or USB hub.
The first time the headset adapter is plugged in, a delay occurs while
Windows configures the device and locates the appropriate driver
software. During the installation, you are prompted to supply the original
Windows CD-ROM so Windows can locate the required drivers.
6 Install the IP Softphone 2050.
7 Configure the IP Softphone 2050 parameters. Click the Server tab in the
Settings window and choose one of the following:
• To manually configure the IP Softphone 2050 parameters, enter the
IP address of the Call Server, Server type, port number, and retries.
• For DHCP, select the check box beside Automatic (DHCP). The
IP address, Server type, port number, and retries are automatically
retrieved from the DHCP Server.
Note: For more information about using partial DHCP, see
Procedure 11, "Installing an IP Phone 2004 for the first time using DHCP"
on page 100.
8 Click Apply.
Use the following options to obtain the latest version of the
IP Softphone 2050:
• new installation—installing the IP Softphone 2050 for the first time
• upgrade—upgrading the IP Softphone 2050 to the latest version
IP Softphone (Version 1) and IP Softphone (Version 2) can coexist on a PC,
although both versions cannot run at the same time.
August 2007
End of Procedure