Nortel 1110 Installation And Operation Manual page 408

Page 408 of 630
Configuring the IP Phone 1140E
553-3001-368 Standard 26.00
Nortel IP Phone 1140E
Installation and Configuration (553-3001-212), or IP Line: Description,
Installation, and Operation (553-3001-365).
CAUTION
Damage to Equipment
Do not plug your IP Phone 1140E into an ISDN
connection. Severe damage can result.
You must configure the IP Phone 1140E before you can use it. Use
Procedure 72 on page 408
Procedure 72
Configuring the IP Phone 1140E
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP Line:
Description, Installation, and Operation (553-3001-365), and Software
Input/Output: Administration (553-3001-311).
2 Configure the IP Phone 1140E on the Call Server as IP Phone 2004 using
LD 11. At the prompt, enter the following:
REQ:chg
TYPE:i2004
For more information, see Software Input/Output: Administration (553-
3001-311).
CAUTION
The IP Phone 1140E is shipped with the stand locked in
position. To avoid damaging the IP Phone, press the
wall-mount lever located under the Handsfree key to
release the stand and pull it away from the phone. See
Figure 38 on
August 2007
to configure the IP Phone 1140E for the first time.
page 409.