Nortel 1110 Installation And Operation Manual page 62

Nortel IP Phone 2001
Page 62 of 630
553-3001-368 Standard 26.00
8 (Optional) Customize the feature keys as required. For more information,
see IP Phone 2001 User Guide.
Procedure 3
Installing an IP Phone 2001 for the first time
using DHCP
Timing information
There are only four seconds(s) between plugging in the IP Phone 2001
power transformer and the appearance of the Nortel logo in the middle
of the display. When you see the logo, you have one s to respond by
pressing the four soft keys at the bottom of the display in sequence from
left to right, one at a time. If you miss the one-s response time, the
IP Phone 2001 attempts to locate the connect server. You can begin the
power-up sequence again, or you can double-press the Services key to
open the network diagnostic utilities to access the IP Phone settings.
See Appendix Appendix E:: "IP Phone diagnostic utilities" on
To edit network configuration the following soft keys are available:
• OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
• BkSpace—backspace a configuration entry to change it
• Clear—clear an entire configuration entry
• Cancel—cancels out of network configuration. The IP Phone reboots
without saving changes.
1 When the Nortel logo appears in the middle of the display, immediately
press the four keys at the bottom of the display in sequence from left to
right.
2 At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control. Enter
DeviceID and Password.
August 2007
End of Procedure
IMPORTANT!
page 525.