Replacing An Ip Phone 2004; Procedure 15 - Nortel 1110 Installation And Operation Manual

Page 110 of 630

Replacing an IP Phone 2004

553-3001-368 Standard 26.00
Nortel IP Phone 2004
3 Press OK when the node number displays.
If
the node password is enabled and
is not NULL
the node password is disabled
4 Enter the password at the password screen, and press OK.
A TN screen displays.
Note: To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see
Communication Server 1000 Element Manager: System
Administration (553-3001-332).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
Two IP Phones cannot share the same TN. You must remove the
IP Phone 2004 that is currently using the TN.

Procedure 15

Replacing an IP Phone 2004
1 Obtain the node and TN information of the phone you want to replace.
2 Disconnect the IP Phone 2004 that you want to replace.
3 Follow Procedure 9 on
and configure the IP Phone 2004.
August 2007
Then
a password screen displays. Go to
step 4.
a TN screen displays. Go to
step 5.
End of Procedure
IMPORTANT!
page 89 or Procedure 11 on page 100 to install