Nortel 1110 Installation And Operation Manual page 178

Page 178 of 630
553-3001-368 Standard 26.00
Nortel IP Phone 2007
When the Network Configuration menu opens, Enable 802.1x Auth.
(EAP) is the first option in the list.
1 Use the Right navigation key to scroll and highlight the Enable 802.1x
Auth. (EAP): list box.
2 Press the Down navigation key to open list box.
3 Use the Up/Down navigation keys to scroll and highlight Yes to enable
802.1x Authentication, or No to disable 802.1x Authentication.
4 If 802.1x Authentication is enabled, use the dialpad to fill in the following
information:
• Device ID
• Password
• Retype the password
Note: Use the dialpad to enter digits only. To enter alpha characters, use
either the IP Phone 2007 pop-up keyboard, or a USB keyboard.
For further information about EAP, see Appendix Appendix C:: "802.1x
Port-based network access control" on
Note: If you do not enable 802.1x Authentication, you are not prompted
to enter Device ID and Password.
5 Use the Right navigation key to scroll and highlight Enable 802.1x (LLDP
Enable).
For more information about LLDP, see Appendix Appendix D:: "802.1ab
Link Layer Discovery Protocol" on
6 Use the Up/Down navigation keys to scroll and highlight Yes to enable
LLDP, or No to disable LLDP.
7 Use the Right navigation key to scroll and highlight DHCP combo box.
8 Press the Down navigation key to open list box.
9 Use the Up/Down navigation keys to scroll and highlight one of the
following DHCP options:
• No—disable DHCP support and enter IP network information
manually.
• Partial—IP network information (IP address, network mask, and
gateway address) are provided by the DHCP server. Enter Server 1
August 2007
page 521.
page 523.