Nortel 1110 Installation And Operation Manual page 343

Redeploying an IP Phone 1110
You can redeploy an existing previously configured IP Phone 1110 on the
same Call Server. For example, the IP Phone 1110 can be assigned to a new
user (new TN) or to an existing user who moved to a new subnet by changing
the TN of the IP Phone 1110. For further information, see Data Networking
for Voice over IP (553-3001-160).
Procedure 62
Changing the TN of an existing IP Phone 1110
1 Repower the IP Phone 1110.
Note: During the reboot sequence of a previously configured IP Phone,
the IP Phone 1110 displays the existing node number for approximately 5
seconds.
2 If the node password is enabled and NULL, choose one of the following:
a. Disable the password.
b. Set the password as non-NULL.
3 Press OK when the node number displays.
If
the node password is enabled and
is not NULL
the node password is disabled
4 Enter the password at the password screen and press OK.
A TN screen displays.
Note: To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see
Communication Server 1000 Element Manager: System
Administration (553-3001-332).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
Nortel IP Phone 1110
Then
a password screen displays. Go to
step 4.
a TN screen displays. Go to
step 5.
End of Procedure
IP Phones Description, Installation, and Operation
Page 343 of 630