Nortel 1110 Installation And Operation Manual page 602

Page 602 of 630
553-3001-368 Standard 26.00
Appendix G: Bluetooth wireless technology
Note 1: Paired headset information is saved and restored when a reboot
of the IP Phone occurs; therefore, the active wireless headset will remain
paired and active.
Note 2: It is not recommended to pair more than one headset of the
same model because they will have identical names in the Paired list.
Dual Pairing Headsets
Take special care when using a dual pairing type of Bluetooth wireless
technology headset. This headset can be paired to its base as well as to the IP
Phone 1140E and IP Phone 1150E.
If the headset is paired to both, the IP Phone is the second device. When you
press the headset telephone key and you hear a single tone, the headset is
active for a call from the desktop telephone base.
To use the headset with the IP Phone, press and hold the headset's telephone
key for 1 second. You will hear a double beep. The headset is active with the
IP Phone.
If the base is powered off, then the headset is only paired to the IP Phone.
Press the headset's telephone key to connect to the IP Phone.
Note: Unless there is a need to dual pair a headset, operating the headset
with the IP Phone is simpler if the headset is only used with its charging-
only base. The desktop IP Phone base should be powered off if it is not
in use.
Using a wired headset
If you connect a Bluetooth wireless technology headset and a wired handset
to the same IP Phone, the two interact as follows:
• If no wireless headset is paired, the wired headset works as normal.
Likewise, if a wireless headset is paired with an IP Phone but is not in
range, the wired headset works as normal.
• If the Use BT Headset check box is selected, the Bluetooth wireless
technology headset is used as the phone headset.
August 2007
End of Procedure