Nortel 1110 Installation And Operation Manual page 339

PSK SRTP? (0-No, 1-Yes)
GARP Ignore? (0-No, 1-Yes)
You are prompted to enter the TFTP Server IP address if you are using a
TFTP Server to download the current firmware.
For CS 1000 Release 4.5, accept the default value of 0.0.0.0. A TFTP
Server is not required for CS 1000 Release 4.5. With the Enhanced
UNIStim Firmware Download feature, firmware can be automatically
downloaded from the Call Server. For further information about the
Enhanced UNIStim Firmware Download feature, see IP Line: Description,
Installation, and Operation (553-3001-365).
For CS 1000 Release 4.0, a TFTP Server is required to upgrade the
firmware. Enter the TFTP Server IP address.
The IP Phone searches for the TFTP Server for firmware upgrade. If the
file name specified in configuration file is not the same as the current
firmware, the IP Phone downloads the file and upgrades the firmware.
This takes several minutes. When the upgrade is complete, the IP Phone
reboots. For further information about TFTP Server configuration, see
Appendix Appendix H:: "TFTP Server" on
The IP Phone 1110 can support a primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple nodes,
see "Enhanced Redundancy for IP Line Nodes" in IP Line: Description,
Installation, and Operation (553-3001-365).
IP Phone 1110 searches for the connect server.
The IP Phone 1110 registers with the Terminal Proxy Server (TPS) and,
if needed, begins the firmware download. This takes several minutes.
When the download is complete, the IP Phone 1110 resets.
The current Call Server date and time appear on the top line of the display
when the configuration is complete. Soft key labels also appear.
7 Check for dial tone and the correct DN on the display.
Nortel IP Phone 1110
Default 0 (for No)
Default 0 (for No)
End of Procedure
IP Phones Description, Installation, and Operation
Page 339 of 630
page 605.