Nortel 1110 Installation And Operation Manual page 333

The IP Phone searches for the TFTP Server for firmware upgrade. If the
file name specified in configuration file is not the same as the current
firmware, the IP Phone downloads the file and upgrades the firmware.
This takes several minutes. When the upgrade is complete, the IP Phone
reboots. For further information about TFTP Server configuration, see
Appendix Appendix H:: "TFTP Server" on
The IP Phone 1110 can support a primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple nodes,
see IP Line: Description, Installation, and Operation (553-3001-365).
The IP Phone 1110 saves the configuration and then reboots. The
IP Phone 1110 searches for the connect server.
The IP Phone 1110 registers with the Terminal Proxy Server (TPS) and,
if needed, begins the firmware download. This takes several minutes.
When the download is complete, the IP Phone 1110 resets.
The current Call Server date and time appear on the top line of the display
when the configuration is complete. Soft key labels also appear.
6 Check for dial tone and the correct DN on the display.
Use Procedure 59 on
using DHCP.
Nortel IP Phone 1110
End of Procedure
page 334 to install the IP Phone 1110 for the first time
IP Phones Description, Installation, and Operation
Page 333 of 630
page 605.