Nortel 1110 Installation And Operation Manual page 181

S2 PK—the Private key of the alternate Secure Media Controller to which
the IP Phone is connected
25 Press the Enter key to start the edit mode. Use the dialpad to fill in the
information. Set the S2 PK to 6 or 1. This value depends on the S2 Action
configuration.
Press the Enter key to start the edit mode. Use the dialpad to fill in the
information. You must enter a 16-digit hexadecimal number. The default
is ffffffffffffffff.
26 Use the Right navigation key to scroll and highlight VoiceVLAN combo
box. Press the Down navigation key to open the list box.
27 Use the Up/Down navigation keys to scroll and highlight one of the
following options:
• No VLAN
• DHCP—VLAN ID is configured automatically to one of the values
received from the DHCP server
• LLDP MED—VLAN ID is configured automatically to the value
received from 802.1ab LLDP
• LLDP VLAN Name—VLAN ID is configured automatically to the
value received from 802.1ab LLDP
• Manual
Note: If LLDP is disabled, LLDP MED and LLDP VLAN Name modes do
not appear in the list. If DHCP is disabled, DHCP does not appear in the
list.
28 Use the Right navigation key to scroll and highlight VLAN Filter check
box.
If the VLAN Filter is enabled, packets destined for the IP Phone port are
filtered on their MAC address and their VLAN tag. Untagged VLAN
packets and tagged VLAN packets that differ from the Telephony VLAN
ID are prevented from reaching the IP Phone port.
For information about VLAN tagging, Appendix Appendix B:: "802.1Q
VLAN description" on
Note: The VLAN Filter check box will appear dimmed if you select No in
the VoiceVLAN combo box.
29 Use the Right navigation key to scroll and highlight Disable PC Port
check box. Press the Enter key to toggle this item on and off.
Nortel IP Phone 2007
page 511.
IP Phones Description, Installation, and Operation
Page 181 of 630