Nortel 1110 Installation And Operation Manual page 154

Page 154 of 630
Keys and functions
Table 14
IP Phone 2007 keys and functions (Part 1 of 2)
Key
Hold
Goodbye
Handsfree
Headset
Mute
Volume control bar
Message waiting
light/incoming call
indicator
Programmable
line (DN)/feature
keys
(self-labeled)
553-3001-368 Standard 26.00
Nortel IP Phone 2007
Table 14 lists the keys and functions for the IP Phone 2007.
Function
Press the Hold key to put an active call on hold. Tap the flashing line (DN)
soft key to return to the caller on hold.
Press the Goodbye key to terminate an active call.
Press the Handsfree key to activate handsfree.
The LED lights to indicate when the handsfree feature is active.
Press the Headset key to answer a call using the headset or to switch a
call from the handset or handsfree to the headset.
Press the Mute key to listen to the receiving party without transmitting.
Press the Mute key again to return to a two-way conversation. The Mute
key applies to handsfree, handset, and headset microphones.
The Mute LED flashes when the Mute option is in use.
Use the Volume control bar to adjust the volume of the ringer, handset,
headset, speaker, and the Handsfree feature.
Press the right side of the rocker bar to increase volume, the left side to
decrease volume.
The Message waiting indicator turns ON to indicate that a message has
been left for the user. This indicator also flashes when the set ringer is
ON.
Programmable line (DN)/feature keys (self-labeled) are located on the
touch panel display and are configured for various features on the IP
Phones.
A steady LCD light beside a programmable line (DN)/feature key indicates
the feature or line is active. A flashing LCD indicates the line is on hold or
the feature is being programmed.
August 2007