Replacing An Ip Phone 1120E; Removing An Ip Phone 1120E From Service - Nortel 1110 Installation And Operation Manual

Replacing an IP Phone 1120E

Removing an IP Phone 1120E from service

Two IP Phones cannot share the same TN. You must remove the
IP Phone 1120E that is currently using the TN.
Procedure 70
Replacing an IP Phone 1120E
1 Obtain the node and TN information of the phone you want to replace.
2 Disconnect the IP Phone 1120E that you want to replace.
3 Follow Procedure 65 on
IP Phone 1120E.
4 Enter the same TN and Node Number as the IP Phone 1120E you
replaced. The Call Server associates the new IP Phone 1120E with the
existing TN.
Procedure 71
Removing an IP Phone 1120E from service
1 Disconnect the IP Phone 1120E from the network or turn off the power.
Note: The service to the PC is disconnected as well if the PC is
connected to the IP Phone 1120E.
If the IP Phone 1120E was automatically configured, the DHCP lease
expires and the IP address returns to the available pool.
2 In LD 11, enter OUT at the TN prompt.
Nortel IP Phone 1120E
IMPORTANT!
page 365 to install and configure the
End of Procedure
End of Procedure
IP Phones Description, Installation, and Operation
Page 385 of 630