Nortel 1110 Installation And Operation Manual page 40

Nortel IP Phone 2001
Page 40 of 630
Description
553-3001-368 Standard 26.00
This section contains the following procedures:
• Procedure 1, "Configuring the IP Phone 2001" on page 52.
• Procedure 2, "Installing the IP Phone 2001 for the first time using
manual configuration" on page 56.
• Procedure 3, "Installing an IP Phone 2001 for the first time using DHCP"
on page 62.
• Procedure 4, "Enabling Full Duplex mode" on page 69.
• Procedure 5, "Checking Ethernet Statistics" on page 69.
• Procedure 6, "Changing the TN of an existing IP Phone 2001" on
page 71.
• Procedure 7, "Replacing an IP Phone 2001" on page 72.
• Procedure 8, "Removing an IP Phone 2001 from service" on page 72.
Note: After an IP Phone has been installed and configured, if power to
the phone is interrupted, re-entry of the IP parameters, Node Number,
TN, or re-acquisition of firmware is not required.
The IP Phone 2001 uses the customer IP data network to communicate with
the Communication Server 1000. The IP Phone 2001 translates voice into
data packets for transport using Internet Protocol. A Dynamic Host
Configuration Protocol (DHCP) server can be used to provide information
that enables the IP Phone 2001 network connection, and connection to the
Communication Server 1000.
Figure 1 on page 41
August 2007
shows the IP Phone 2001.