Introduction; Description - Nortel 1110 Installation And Operation Manual

Page 430 of 630

Introduction

Description

553-3001-368 Standard 26.00
Nortel IP Phone 1150E
This section explains how to install and maintain the IP Phone 1150E. For
information on using the IP Phone 1150E, see the IP Phone 1150E User
Guide, or the IP Phone 1150E Getting Started Card.
This section contains the following procedures:
• Procedure 79, "Configuring an IP Phone 1150E" on page 454.
• Procedure 79, "Configuring an IP Phone 1150E" on page 454.
• Procedure 81, "Enabling Full Duplex mode" on page 471.
• Procedure 82, "Checking Ethernet Statistics" on page 472.
• Procedure 83, "Changing the TN of an existing IP Phone 1150E" on
page 474.
• Procedure 84, "Replacing an IP Phone 1150E" on page 475.
• Procedure 85, "Removing an IP Phone 1150E from service" on
page 475.
Note: After an IP Phone is has been installed and configured, if power
to the phone is interrupted, it is not necessary to reenter IP parameters,
Node Number, TN, nor firmware again.
The IP Phone 1150E uses the customer IP data network to communicate with
the Communication Server 1000. The IP Phone 1150E translates voice into
data packets for transport using Internet Protocol. A Dynamic Host
Configuration Protocol (DHCP) server can be used to provide information
that enables the IP Phone 1150E network connection, and connection to the
Communication Server 1000.
The IP Phone 1150E is configured for either an Agent, or a Supervisor. The
IP Phone 1150E is shipped with Agent key configuration but can be modified
to support Supervisor key configuration by replacing the key caps. Remove
the key caps using the Key Cap removal tool (product number NTNM19AA).
For information about IP Phone 1150E components, see "Package
components" on page 451.
August 2007