Removing An Ip Phone 2007 From Service - Nortel 1110 Installation And Operation Manual

Replacing an IP Phone 2007

Removing an IP Phone 2007 from service

6 Enter the new TN.
Two IP Phones cannot share the same TN. You must remove the IP
Phone 2007 that is currently using the TN.
Procedure 30
Replacing an IP Phone 2007
1 Obtain the node and TN information of the phone you want to replace.
2 Disconnect the IP Phone 2007 that you want to replace.
3 Follow Procedure 25 on
2007.
Enter the same TN and Node Number as the IP Phone 2007 you
replaced. The system associates the new IP Phone 2007 with the existing
TN.
Procedure 31
Removing an IP Phone 2007 from service
1 Disconnect the IP Phone 2007 from the network or turn the power off.
Note: The service to the PC is disconnected as well if the PC is
connected to the IP Phone 2007.
If the IP Phone 2007 was automatically configured, the DHCP lease
expires and the IP address returns to the available pool.
Nortel IP Phone 2007
End of Procedure
IMPORTANT!
page 173 to install and configure the IP Phone
End of Procedure
IP Phones Description, Installation, and Operation
Page 189 of 630