Nortel 1110 Installation And Operation Manual page 177

Table 19
IP Phone 2007 IP parameters (Part 2 of 2)
Parameter
Default Gateway Address
Connect Server (IP address, port,
action and retry count — primary
and secondary)
User ID (Node ID, Node Password
and TN)
Method of Acquisition
Manually entered or automatically retrieved through
Partial or Full DHCP.
Manually entered or automatically retrieved through Full
DHCP.
Manually entered for first-time configuration. Retrieved
from local storage on subsequent power cycles.
Installing the IP Phone 2007
To install the IP Phone 2007, use Procedure 26 on
Procedure 26
Installing the IP Phone 2007
Timing information
There are only 4 s between plugging in the IP Phone 2007 power
adapter and the appearance of Nortel on the display. When Nortel
appears in the middle of the screen, you have 1 s to respond by pressing
0, 0, 7, *. If you miss the 1-s response time, the IP Phone 2007 attempts
to locate the connect server. You can begin the power-up sequence
again, or you can double-press the Services key to open the Local
diagnostic utilities to access the IP Phone settings. See
Appendix Appendix E:: "IP Phone diagnostic utilities" on
Note: You can press the Apply&Reset soft key at any time to apply the
current configuration and reset the phone. You can press the Exit soft key
to exit the menu without saving any changes and return to the Network
Configuration menu.
Nortel IP Phone 2007
IMPORTANT!
IP Phones Description, Installation, and Operation
Page 177 of 630
page 177.
page 525.