Nortel 1110 Installation And Operation Manual page 197

LD 11 – Configure the IP Phone KEM (Part 4 of 5)
Prompt Response
PAGEOFST <Page>
<KeyOffset>
IP Phone Key Expansion Module (KEM)
Description
On the M3903, keys 4-15 are blocked. No feature
assignment is accepted for keys 2-15.
On the M3903, M3904, and M3905, keys 29-31 are
reserved. No feature assignment is accepted for keys
29-31 other than NUL.
On M3904, no feature assignment is accepted for keys
12-15.
On M3905, the craftsperson can assign NUL or a server
application on key 5. On key 6, the craftsperson can
assign NUL or a local application.
On M3905, the craftsperson can assign NUL or the
program key on key 7.
On M3905, the craftsperson can assign AAG, AMG,
ASP, DWC, EMR, MSB, or NRD on keys 8-11. Other
features are blocked.
Automatically calculates the IP Phone KEM key based
on the entered values. This prompt enables the system
administrator to enter a Page number of 0 or 1 and a Key
Offset number from 0-23. Once entered, the KEY
prompt is prompted with the appropriate KEY value filled
in.
Enter <CR> to terminate data entry.
Note 1: Applies to an IP Phone 2004 with
KEM = 1, and where <CR> was entered at the KEY
prompt.
Note 2: Does not apply to an IP Phone 2002.
When values are entered for Page and KeyOffset, the
KEY xx prompt displays, followed by PAGEOFST
prompt. This loop continues until no values (<CR> only)
are entered at the PAGEOFST prompt.
IP Phones Description, Installation, and Operation
Page 197 of 630