Nortel 1110 Installation And Operation Manual page 365

Installation and Configuration (553-3001-212), or IP Line: Description,
Installation, and Operation (553-3001-365).
Configuring the IP Phone 1120E
You must configure the IP Phone 1120E before you can use it. Use
Procedure 65 on
Procedure 65
Configuring the IP Phone 1120E
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see IP Line:
Description, Installation, and Operation (553-3001-365), and Software
Input/Output: Administration (553-3001-311).
2 Configure the IP Phone 1120E on the Call Server as IP Phone 2002 using
LD 11. At the prompt, enter the following:
REQ:chg
TYPE:i2002
For more information, see Software Input/Output: Administration (553-
3001-311).
Nortel IP Phone 1120E
CAUTION
Damage to Equipment
Do not plug your IP Phone 1120E into an ISDN
connection. Severe damage can result. The
IP Phone 1120E does not support multiple devices
connected through the PC Ethernet port.
page 365 to configure the IP Phone 1120E for the first time.
CAUTION
The IP Phone 1120E is shipped with the stand locked in
position. To avoid damaging the IP Phone, press the
wall-mount lever located under the Handsfree key to
release the stand and pull it away from the phone. See
Figure 32 on page
IP Phones
366.
Description, Installation, and Operation
Page 365 of 630