Nortel 1110 Installation And Operation Manual page 369

Figure 35
Cable routing tracks
5 Install the handset. Connect the end of the handset cable with the short
straight section into the handset. Connect the end of the handset cable
with the long straight section to the back of the phone, using the RJ-9
handset jack marked with the symbol
and then thread the handset cord through the channels in the stand so
that it exits behind the handset on the right side, in the channel exit in the
stand base marked with the symbol
6 Install the Ethernet cable. Connect one end of the supplied Ethernet cable
to the back of your phone using the RJ-45 connect marked with the
%
symbol , and thread the network cable through the channel marked with
%.
the symbol
Nortel IP Phone 1120E
.
+
.
+
See Figure 35.
IP Phones Description, Installation, and Operation
Page 369 of 630
Form a small bend in the cable,