Nortel 1110 Installation And Operation Manual page 184

Page 184 of 630
553-3001-368 Standard 26.00
Nortel IP Phone 2007
For Succession Release 3.0 or CS 1000 Release 4.0, the IP Phone 2007
searches for the TFTP Server for firmware upgrade. If the file name
specified in i2007.cfg is not the same as the current firmware, the IP
Phone downloads the file and upgrades the firmware. This takes several
minutes. When the upgrade is complete, the IP Phone 2007 reboots.
Note: The Enhanced UNIStim firmware download is only supported on
CS 1000 Release 4.5 or later.The Enhanced UNIStim firmware download
feature for IP Phones provides an improved method of delivering new
firmware to IP Phones. For further information on Enhanced UNIStim
Firmware Download, see IP Line: Description, Installation, and Operation
(553-3001-365).
The IP Phone 2007 can support a primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple nodes, see
"Enhanced Redundancy for IP Line Nodes" in IP Line: Description,
Installation, and Operation (553-3001-365).
The IP Phone 2007 searches for the connect server.
The IP Phone 2007 registers with the Terminal Proxy Server (TPS) and,
if needed, begins the firmware download. This takes several minutes.
When download is complete, the IP Phone 2007 resets.
The current system date and time appear on the top line of the display
when the configuration is complete. Self-labeling keys also appear.
41 Check for dial tone and the correct DN above the display.
42 (Optional) Customize the feature keys as required. For more information,
see the IP Phone 2007 User Guide.
43 Tap the Tools icon to calibrate the touch panel and stylus.
44 Tap the Touch Panel Setup soft key.
The screen displays a calibration map, the Cancel soft key is displayed,
and the following system prompt is displayed:
Touch the center of the red ball.
45 Use the stylus and tap each of the red dots, in order, starting with the
lower left portion of the screen, and following the sequence as prompted.
After the third dot is tapped, the display changes to indicate the result of
calibration.
— If the calibration is successful, the telephone displays the following
report:
August 2007