Nortel 1110 Installation And Operation Manual page 595

Appendix G: Bluetooth wireless technology
Figure 72
Sample of the 1140E.cfg file
[FW]
DOWNLOAD_MODE AUTO
VERSION 0625Cxx
FILENAME 0625Cxx.bin
PROTOCOL TFTP
SERVER_IP 192.168.1.100
SECURITY_MODE 0
[DEVICE_CONFIG]
DOWNLOAD_MODE FORCED
VERSION 000001
FILENAME 1140eDEV.cfg
SERVER_IP 192.168.1.100
Figure 73
Sample of the DEVICE_CONFIG file with only the [DEVICE_CONFIG]
section
[DEVICE_CONFIG]
DOWNLOAD_MODE FORCED
VERSION 000001
FILENAME 1140eDEV.cfg
SERVER_IP 192.168.1.100
4 Start the TFTP Server. The TFTP Server must be running on the network
when the IP Phone 1140E powers up to retrieve the Bluetooth wireless
technology administrative control. After you put the 1140e.cfg and the
device config file in the TFTP Server directory, ensure the TFTP Server is
running then reboot the IP Phone 1140E. For information about TFTP
Server configuration, see Appendix Appendix H:: "TFTP Server" on
page 605.
Once the IP Phone 1140E retrieves the setting when the IP Phone 1140E
restarts, it is saved in persistent memory. If the Enable BT setting is set to
Auto, then the received value is acted on and Bluetooth wireless
technology is either enabled or disabled on the IP Phone 1140E. If the
Device Config file with the Enable BT setting is not received for any
reason and the Enable Bluetooth mode is set to Auto, then the phone
uses the last value received (retrieved from persistent memory).
IP Phones Description, Installation, and Operation
Page 595 of 630