Nortel 1110 Installation And Operation Manual page 94

Page 94 of 630
553-3001-368 Standard 26.00
Nortel IP Phone 2004
3 At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for
No).
For more information about LLDP, see Appendix Appendix D:: "802.1ab
Link Layer Discovery Protocol" on
4 At the prompt DHCP Yes/No?, enter 0-N (0 for No).
By default, Full DHCP is configured on the IP Phone 2004. Depending on
the configuration requirements, you can change the IP Phone 2004
configuration to allow the following IP address assignments:
• Static—enter all parameters
• Partial DHCP—IP Phone address, subnet mask, and default
Gateway are obtained from the DHCP server
• Full DHCP— (default) all parameters are obtained from the DHCP
server
Note: A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, see Data Networking for Voice over IP (553-3001-160).
5 Enter the following information:
Screen prompt
set IP
net msk
def gw
August 2007
page 523.
Description
a valid IP Phone 2004 IP address
a subnet mask
the default Gateway for the IP Phone 2004 on
the LAN segment to which it is connected