Nortel 1110 Installation And Operation Manual page 137

Data VLAN? (0-No, 1-Yes)
Data VLAN Cfg? (0-A, 1-M)
Data VLAN ID:
Duplex? (0-Auto, 1-Full)
PSK SRTP? (0-No, 1-Yes)
GARP Ignore? (0-No,1-Yes)
Note: You are prompted to enter the TFTP Server IP address if you are
using a TFTP Server to download the current firmware. For CS 1000
Release 4.5, accept the default value of 0.0.0.0. For Succession Release
3.0 or CS 1000 Release 4.0, enter the TFTP Server IP address. The
IP Phone searches for the TFTP Server for firmware upgrade. If the file
name specified in configuration file is not the same as the current
firmware, the IP Phone downloads the file and upgrades the firmware.
This takes several minutes. When the upgrade is complete, the IP Phone
reboots. For further information about TFTP Server configuration, see
Appendix Appendix H:: "TFTP Server" on
The IP Phone 2002 can support a primary (S1) and secondary (S2)
connect server. If you require IP Phones to register on multiple nodes, see
"Enhanced Redundancy for IP Line Nodes" in IP Line: Description,
Installation, and Operation (553-3001-365).
The IP Phone 2002 searches for the connect server. When the
connection is complete, proceed with step 6.
Nortel IP Phone 2002
If you select 1-Y (1 for Yes), and if
LLDP is enabled, the Data VLAN Cfg
prompt appears on the display.
This prompt is not displayed if the PC
port prompt is set to OFF.
If you select 0 (0 for A), VLAN ID is
configured automatically to the value
received in the VLAN NAME TLV.
This prompt is not displayed if Data
VLAN, or LLDP is not enabled.
This prompt is displayed if Data
VLAN is enabled but LLDP is not
enabled.
Default 0 (for Auto)
Default 0 (for No)
Default 0 (for No)
IP Phones Description, Installation, and Operation
Page 137 of 630
page 605.