Accessing Network Diagnostic Utilities From The Ip Phone - Nortel 1110 Installation And Operation Manual

Authentication State
The system administrator uses this option to determine whether the IP Phone
is currently authenticated with the 802.1x system. The following are valid
state values:
• LogOff
• Disconnected
• Connected
• Acquired
• Authorizing
• Held
• Authorized
• Dbl Authd
DeviceID
The system administrator uses this option to check the user name configured
for the device that is sent to the switch for authentication. This should match
the corresponding entry in the RADIUS Server.
Authenticator ID
The system administrator uses this option to check the MAC address of the
Authenticator (switch).

Accessing Network Diagnostic utilities from the IP Phone

Local diagnostics are available from the IP Phone for either Local or Remote
mode.
Note: Diagnostics prompts are presented in English.
Local Mode
When the IP Phone is not registered with the signaling server, the Network
Diagnostic Tools menu is available from the IP Phone in Local Mode (see
Table 68, "Network Diagnostic Utilities availability," on page 527). This
menu is controlled by the firmware on the IP phone.
Appendix E: IP Phone diagnostic utilities
IP Phones Description, Installation, and Operation
Page 529 of 630