Configuration - Nortel 1110 Installation And Operation Manual

Configuration

LD 11 - Configure the Expansion Module for IP Phones 1100 Series (Part 1 of 2)
Prompt
REQ:
TYPE
...
KEM
...
CLS
KEY
PAGEOFST
Expansion Module for IP Phone 1100 series
Use LD 11 to configure the Expansion Module for IP Phones 1100 Series.
Response
NEW/CHG
1120,1140,1150
...
(0) - 3/<CR>
...
KEM3
0 - <see text>/
<CR>
<Page> <KeyOff-
set> / <CR>
Description
Add new or change existing data.
For IP Phone1120E, IP Phone 1140E, and IP Phone
1150E
...
Number of attached Expansion Modules (0). Up to
three Expansion Modules are supported.
...
KEM3 CLS must be defined
Key number range expanded to support number of
Expansion Modules specified by KEM prompt. The
range on the IP Phone is as follows:
KEM value:
0
1
2
3
PAGEOFST is prompted if one Expansion Modules is
specified at the KEM prompt and <CR> is entered at
the KEY prompt. This prompt enables you to enter a
Page number of 0, or 1, and a Key Offset number
from 0 to 17. Once entered, the KEY is prompted
with the appropriate KEY value filled in. <CR> ends
the input.
IP Phones Description, Installation, and Operation
Page 481 of 630
KEY range:
0 - 31
32- 49
50- 67
68- 85