Nortel 1110 Installation And Operation Manual page 407

• Startup sequence
• Installing the IP Phone 1120E
Before you begin
Before installing the IP Phone 1140E, complete the following pre-installation
checklist:
• Ensure there is one IP Phone 1140E boxed package for each
IP Phone 1140E being installed. The package contains:
— IP Phone 1140E
— handset
— handset cord
— 2.1 m (7 ft) CAT5 Ethernet cable
— Number plate and lens
— Getting Started Card
• Ensure there is one Software License for each IP Phone 1140E being
installed.
• Ensure the host Call Server is equipped with the Voice Gateway Media
Card, or a Signaling Server with the Line TPS application.
• If an AC power adapter is required, ensure the approved Nortel global
power supply (model # N0089601) is used. See Table 47, "IP Phone
1140E component list," on page 405.
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server:
Nortel IP Phone 1140E
IP Phones Description, Installation, and Operation
Page 407 of 630