Introduction; Description - Nortel 1110 Installation And Operation Manual

Page 346 of 630

Introduction

Description

553-3001-368 Standard 26.00
Nortel IP Phone 1120E
This section explains how to install and maintain the IP Phone1120E. For
information on using the IP Phone 1120E, see the IP Phone 1120E User
Guide (NN43112-103).
This section contains the following procedures:
• Procedure 65, "Configuring the IP Phone 1120E" on page 365.
• Procedure 65, "Configuring the IP Phone 1120E" on page 365.
• Procedure 67, "Enabling Full Duplex mode" on page 381.
• Procedure 68, "Checking Ethernet Statistics" on page 382.
• Procedure 69, "Changing the TN of an existing IP Phone 1120E" on
page 384.
• Procedure 70, "Replacing an IP Phone 1120E" on page 385.
• Procedure 71, "Removing an IP Phone 1120E from service" on
page 385.
Note: After an IP Phone has been installed and configured, if power to
the phone is interrupted, re-entry of the IP parameters, Node Number,
TN, or re-acquisition of firmware is not required.
The IP Phone 1120E uses the customer IP data network to communicate with
the Communication Server 1000. The IP Phone 1120E translates voice into
data packets for transport using Internet Protocol. A Dynamic Host
Configuration Protocol (DHCP) server can be used to provide information
that enables the IP Phone 1120E network connection, and connection to the
Communication Server 1000.
Figure 30 on page 347
August 2007
shows the IP Phone 1120E