Nortel 1110 Installation And Operation Manual page 292

Page 292 of 630
553-3001-368 Standard 26.00
Nortel IP Audio Conference Phone 2033
A DHCP server and DHCP relay agents must also be installed,
configured, and running if you choose Partial DHCP, or Full DHCP
configuration.
For more information on how to set up DHCP servers for use with the
IP Phones, see Data Networking for Voice over IP (553-3001-160).
3 At the prompt, Cached IP?, select 0 (0-No, default) to conform to the
DHCP standard and to obtain an IP address from the DHCP server. Only
select 1 (1 for Yes) to force the IP Phone to start with a cached IP address
in the event that the IP Phone cannot connect to the DHCP server and
obtain an IP address.
4 Select Partial or Full DHCP.
a. If you select Full DHCP, then the following parameters are retrieved
from the DHCP server:
— a valid IP Audio Conference Phone 2033 IP address
— a subnet mask
— the default Gateway for the IP Audio Conference
Phone 2033 on the LAN segment to which it is connected
— the S1IP. The primary CS 1000 node IP address of the IP
Phone.
— the S1 action
— the S1 retry count. This is the number of times the IP Audio
Conference Phone 2033 attempts to connect to the server
— the S2 IP. The secondary CS 1000 node IP address of the IP
Phone.
— the S2 action
— the S2 retry count
b. If you select Partial DHCP, then you must enter the following
parameters
Screen prompt
S1 IP
S1 Port
August 2007
Description
The primary CS 1000 node IP address
of the IP Audio Conference Phone 2033.
this is a fixed value: 4100