Nortel 1110 Installation And Operation Manual page 453

• First-time installation
• Configuring the IP Phone 1150E
• Startup sequence
• Installing the IP Phone 1150E
Before you begin
Before installing the IP Phone 1150E, complete the following pre-installation
checklist:
• Ensure there is one IP Phone 1150E boxed package for each
IP Phone 1150E being installed. The package contains:
— IP Phone 1150E
— 2.1 m (7 ft) CAT5 Ethernet cable
— Getting Started Card
• Ensure there is one Software License for each IP Phone 1150E being
installed.
• Ensure the host Call Server is equipped with the Voice Gateway Media
Card, or a Signaling Server with the Line TPS application.
• If an AC power adapter is required, ensure the approved Nortel global
power supply (model # N0089601) is used. See Table 56, "IP Phone
1150E component list," on page 451.
First-time installation
You must first install an IP Telephony Node with the Communication Server.
For information about installing an IP Telephony Node, see Signaling Server:
Installation and Configuration (553-3001-212), or IP Line: Description,
Installation, and Operation (553-3001-365).
Nortel IP Phone 1150E
CAUTION
Damage to Equipment
Do not plug your IP Phone 1150E into an ISDN
connection. Severe damage can result.
IP Phones Description, Installation, and Operation
Page 453 of 630