Nortel 1110 Installation And Operation Manual page 132

Page 132 of 630
553-3001-368 Standard 26.00
Nortel IP Phone 2002
Procedure 18
Installing the IP Phone 2002 for the
first time using manual configuration
Timing information
There are only four seconds (s) between plugging in the IP Phone 2002
power transformer and the appearance of the Nortel logo in the middle
of the display. When you see the logo, you have one s to respond by
pressing the four soft keys at the bottom of the display in sequence from
left to right, one at a time. If you miss the one-s response time, the
IP Phone 2002 attempts to locate the connect server. You can begin the
power-up sequence again, or you can double-press the Services key to
open the network diagnostic utilities to access the IP Phone settings.
See Appendix Appendix E:: "IP Phone diagnostic utilities" on
To edit network configuration the following soft keys are available:
• OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
• BkSpace—backspace a configuration entry to change it
• Clear—clear an entire configuration entry
• Cancel—cancels out of network configuration. The IP Phone reboots
without saving changes.
1 At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control. Enter
DeviceID and Password.
If you select No, you are not prompted to enter Device ID and Password.
For more information on EAP, see Appendix Appendix C:: "802.1x Port-
based network access control" on
2 At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for
No).
For more information about LLDP, see Appendix Appendix D:: "802.1ab
Link Layer Discovery Protocol" on
August 2007
IMPORTANT!
page 521.
page 523.
page 525.